Domestic Appliance Forum

LOGIK Washing Machine Error Codes

Logik Washing Machine Error 02:

Error Code Definition: The water level in your machine is below the heater. The pressure of your water may be too low.

Logik Washing Machine Error 03:

Error Code Definition: The pump had failed or the pump is obstructed.

Logik Washing Machine Error 05:

Error Code Definition: The heater or heat sensor has failed.

Logik Washing Machine Error 06:

Error Code Definition: The motor has failed.

Logik Washing Machine Error 10: “E10”

Error Code Definition: Water drain time out or failure

The washing machine has failed to drain the water in allotted time (6 minutes).

How To Clear Error Code:

-Check that filter is not blocked or kinked

-Check drain hose is clear of blockage or kinks

-Check wires to drain pump

-Check drain pump is not faulty

-Check level sensor and switch

-Check wires to level sensor

Logik Washing Machine Error 12: “E12”

Error Code Definition: Washing machine has detected overfill.

This error code can be caused by over sudsing from overloading or by adding too much detergent.

The pressure sensor will read that there is too much water in the washer.

How To Clear Error Code:

-Check for sudsing
-Check the air chamber & the pressure switch hose

-Check water level sensor

-Check the wiring to water pressure sensor

-Check connections to water level sensor

-Check main electronic control board

Logik Washing Machine Error 21: “E21”

Error Code Definition: Washer has not drained in allotted / time washer not draining.

How To Clear Error Code:

-Check that filter is not blocked or kinked

-Check drain hose is clear of any blockage or kinked

-Check wires to drain pump

-Check drain pump is not faulty

-Check level sensor and switch

-Check wires to level sensor

Logik Washing Machine Error 30: “E30”

Error Code Definition: Washer door lock not operational operate and or not responding.

Error with the door safety lock switch or interlock prevent operation.

How To Clear Error Code:

-Check that door is closed and shut properly

-Check wires to door switch

-Check door lock for faults

Logik Washing Machine Error 30: “E60”

Error Code Definition: Washer motor failure or fault.

Washers main drive motor circuit error.

How To Clear Error Code:

-Check motor connection block

-Check motor carbon brushes to see if worn

-Check wires

-Check tachometer connections

-Check motor for other faults

Logik Washing Machine Error 61: “E61”

Error Code Definition: Motor tachometer generator fail.

Error on the washers main drive motor circuit in connection with overheat protector in the motor.

How To Clear Error Code:

-Check motor connection block

-Check motor carbon brushes for wear

-Check wiring

-Check tachometer connections

-Check motor for other faults