I have a Bosch WVH28440. It starts a program, fills, starts to turn for a while (about 5 minutes into it) and then it goes into a cycle where some relays click and then the display blanks, all LEDS then flash on, and it tries to run again, 10s later it does the same cycle.
I've been trying to find the method to put it in error/code test mode, but what i find online doesnt work for mine. Except one procedure (dial at off, hold delicates, dial to 8, dial to 9, release delicates) shows an E00 (no error)
I'm thinking its the motor control, and i am an electronics engineer, if i could confirm this i'd get the board out and see if its repairable.
Obvioulsy urgent as we are in coronoa isolation and i need it