Domestic Appliance Forum
Having a fault issue with an AEG T59840 condensor drier.
Returns a fault code E32, but I am not convinced it is a conductimetric sensor fault, brushes worn/faulty or electronic board fault.
Symptoms: clothes do not dry, water collects in tray beneath condensor but not in water reservoir. Clothes heat (indicating not a heater issue), filters and condensor clean, running water pump diagnosic - pump switches on, pumps water to reservoir OK.
To me this points towards the issue being recognition of water in the condensor collection tray and turning on the pump. Is there a level sensor in the tray or does the pump normally run continuously?
Returns a fault code E32, but I am not convinced it is a conductimetric sensor fault, brushes worn/faulty or electronic board fault.
Symptoms: clothes do not dry, water collects in tray beneath condensor but not in water reservoir. Clothes heat (indicating not a heater issue), filters and condensor clean, running water pump diagnosic - pump switches on, pumps water to reservoir OK.
To me this points towards the issue being recognition of water in the condensor collection tray and turning on the pump. Is there a level sensor in the tray or does the pump normally run continuously?
There are no replies made for this post yet.