Domestic Appliance Forum
I have a new hob fitted, lpg jets, I cannot adjust the gas pressure down as the adjuster screws are underneath the stainless steel body.
Is there a way to get to them without grinding the steel body away?
I realise that any cutting will not be seen as it’s under the control knobs, but it appears to be a very poor design for me to have to do this.
I did ask an engineer to help but he was not interested.
Is there a way to get to them without grinding the steel body away?
I realise that any cutting will not be seen as it’s under the control knobs, but it appears to be a very poor design for me to have to do this.
I did ask an engineer to help but he was not interested.
Norman Collins set the post as Critical priority — 2 years ago
Norman Collins set the type of the post as Advice — 2 years ago
There are no replies made for this post yet.